Note on archived topics.

This topic has been archived. Information and links in this thread may no longer be available or relevant.
If you have a question create a new topic by clicking here and select the appropriate board.
NSX-Reg Honor Student
Honor Student
3 0 0
Message 1 of 3
667
Flag Post

Using BCU with MDT or SCCM

Microsoft Windows 7 (64-bit)

Has anyone been able to incoporate the Bios Config Utility into an MDT task sequence?

 

I've created a task sequence that runs in WinPE that replicates BIO settings, Enable Legacy Disable Secure Boot, using BCU that has a 70% success rate. Cannot deciper the logs and lookup the error I receive when the task fails.

 

Any help or advice would be greatly appreciated!

 

 

-R 

2 REPLIES
Intern Intern
Intern
40 1 5
Message 2 of 3
645
Flag Post

Using BCU with MDT or SCCM

Hello,

 

 

The below whitepaper could help you :

 

 

ftp://ftp.hp.com/pub/caps-softpaq/cmit/whitepapers/Building,%20Deploying,%20and%20Updating%20an%20Im...

 


Try to uses the latest version of the BCU :

 

 

http://ftp.hp.com/pub/caps-softpaq/cmit/HP_BCU.html

 

 

All The Best

 

0 Kudos
NSX-Reg Honor Student
Honor Student
3 0 0
Message 3 of 3
630
Flag Post

Using BCU with MDT or SCCM

I've tried the new version, same results.

0 Kudos

Note on archived topics.

This topic has been archived. Information and links in this thread may no longer be available or relevant.
If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation