hp compaq dc7100 will not start.

[rodriguezj2]

my hp compaq dc7100 will  not start. getting 4 beeps with 4 red light pulses.  any ideas on what is going on or what went out and needs replacing?

[Paul_Tikkanen]

Hi:

Here is the list of beep codes for your PC:

Power LED # Beeps Event

Steady green None S0 System on (normal operation)

Blinks green @ 0.5 Hz None S1 Suspend

Blinks green @ 0.5 Hz None S3 Suspend to RAM

Off (clear) None S4 Suspend to disk

Off (clear) None S5 Soft off

Blinks red 2 times @ 1 Hz [1] 2 Processor thermal shutdown

Blinks red 3 times @ 1 Hz [1] 3 Processor not seated / installed

Blinks red 4 times @ 1 Hz [1] 4 Power supply failure

Blinks red 5 times @ 1 Hz [1] 5 Memory error

Blinks red 6 times @ 1 Hz [1] 6 Video error

Blinks red 7 times @ 1 Hz [1] 7 PCA failure

Blinks red 8 times @ 1 Hz [1] 8 Invalid ROM checksum (error)

Blinks red 9 times @ 1 Hz [1] 9 Wrong power supply input voltage

Blinks red10 times @ 1 Hz [1] 10 Bad option card

NOTE: Power LED blinks are repeated after a 2 second pause until issue is resolved,.

Beeps continue for 5 iterations and then stop.

Paul

[bolsomarce]

I have a DC7100. Blinks red 9 times @ 1 Hz [1] 9 Wrong power supply input voltage. Solution?

[Paul_Tikkanen]

Hi:

Here are the possible solutions to the 9 Beeps:

1. Check that the voltage selector, located on the rear of the power supply (some models), is set to the appropriate voltage. Proper voltage setting depends on your region.

2. Replace the system board.

3. Replace the processor.

[Cp32]

Mine Beeps 5 times.What should I do??

[Cp32]

Help

[chris127]

My dc7100 keep blowing psu power supply each time i replaced it, what could be the cause?