cancel
Showing results for 
Search instead for 
Did you mean: 
XboxOneS
New member
2 1 0 0
Message 1 of 2
107
Flag Post

I recently connected my Xbox One S to my HP P244 23.8 Inch Monitor, February 2020 with an HDMI cord.

HP Recommended
HP P244

I recently connected my Xbox One S to my HP P244 23.8 Inch Monitor, February 2020 with an HDMI cord. I was fiddling with the settings on the Xbox, and all of a sudden when I switched the Refresh Rate from 60 Hz to 120 Hz, the screen went black. I turned on my monitor again, and the same message keeps popping up and it says"

 

Input signal out of range!

Current Mode:

                H = 135.2kHz, V = 120 Hz

Change Mode to:

                 1920x1080 60 Hz.

Dispplay going to sleep in 30 Seconds

 

I now can't access my Xbox on the monitor, and I would appreciate some help from someone to fix this. Thanks!

1 REPLY 1
XboxOneS
Author
New member
2 1 0 0
Message 2 of 2
Flag Post
HP Recommended

Ok never mind I got it. Hold down the Console button for 10 seconds until it completely turns off. Then hold on the small black button on the bottom of the console, then press once the Xbox console button while still holding onto the bottom black button. It will then make a second beep, and then your hp will appear very blurry as a 640hp. Now you can control and go back to the settings and change the resolution back. 

Reply
0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation