• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
The HP Community is where owners of HP products, like you, volunteer to help each other find solutions.
Locked

‎02-10-2021 05:54 PM - edited ‎02-10-2021 05:56 PM

HP Recommended
Product: OMEN 30L Desktop GT13-0380t
Operating System: Microsoft Windows 10 (64-bit)

I have installed XPG SX8200 Pro 1TB as my second SSD. The sequential read/write speed should up to 3500/3000 MB/s, but I only get 1600/1800 MB/s. I tried to replace the configuration of SATA from RAID to AHCI, but I could not start my computer after doing so. Therefore I changed it back to RAID. Did I did anything wrong? How do I set up my second SDD to make it run as full speed? Thanks. 

Screenshot 2021-02-07 152219.pngScreenshot 2021-02-10 164836.png

1 REPLY 1

‎02-11-2021 07:28 AM

HP Recommended

Try disabling the RAID before you install the second drive, I remember someone had a similar issue with it. 

Was this reply helpful? Yes No
Warning
Be alert for scammers posting fake support phone numbers and/or email addresses on the community.
If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.