Toolbar

[rnagel]

Is it possible to anchor the toolbar to the far right of the screen/window when a connection session is established instead of the toolbar defaulting to the middle of the screen? 

[KellyRGS]

You can move the receiver tool bar by clicking on the three stacked dots, and dragging the tool bar to where you want it, and then pin it to have it stay visible.

[rnagel]

I understand moving the tool bar with the tree dots, however whether you connect again or to a new session, the tool bar defaults to appearing in the middle of the monitor whether pinned or not. 

Is there a way to have it positioned to the far right or a different location (other than top middle of the monitor) at the start of a new connection? 

[KellyRGS]

This is the other issue you mentioned you were talking to me about.  I was hoping that moving the tool bar and pinning it would keep it from moving when you reconnected.  Let me take a look at this and see if there is a property to position the toolbar.

Kelly

[KellyRGS]

I did some investigation into the Toolbar behavior.  The default behavior is for the tool bar to always return to the center when disconnecting.  I am trying to find out if there is a way to modify this behavior.  Should have answer for you tomorrow.

Kelly

[KellyRGS · Accepted solution]

I tried to see if there was a way to keep the location of the tool bar saved, but was informed that this is not possible.  Due to some problems that were introduced when trying to save the location of the tool bar, a decision was made to bring the tool bar back to the center when ending a session.

Kelly