-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
- HP Community
- Apps, Services & Software
- ZCentral
- Re: set sender to only output/show one display to receivers

Create an account on the HP Community to personalize your profile and ask a question
03-10-2023 10:19 AM
hi all,
ive noticed when a person WFH with 2/3 monitor setup connects to a sender in the office that has only got 1 monitor attached to it, when a person tries to connect in the office, all they get is a blank screen as it still thinks theres 2/3 monitors connected to it, the only way to solve this is connect back again using z boost and right click "display settings" and choose "duplicate these displays" and then they see the desktop
is there anyway on the sender i can stop this from happening ie only make it send out 1 monitor to the receivers
thanks,
rob
03-14-2023 03:43 AM
ok i think i need to put in this in the senders config
Rgreceiver.Display.1.X=0
Rgreceiver.Display.1.Y=0
Rgreceiver.Display.1.Width=1920
Rgreceiver.Display.1.Height=1200
Rgreceiver.Display.1.Orientation=0
but instead of hard choosing a resolution can i make it choose one depending on the clients recievers resolution