Solved: Color Laser Jet Pro 200 Question (Secondary Transfer Roller) - HP Support Community

drewmun · ‎12-26-2017

I have the Color LaserJet Pro 200 M251nw. I purchased a replacement

HP RM1-4445-000CN Secondary Transfer Roller.

How do I replace the transfer roller? I don't want to break anything but It seems
difficult to replace.

drewmun · ‎12-27-2017

Thank you, thank you. Did it with no issues.

View solution in original post

Copier-Pro · ‎12-27-2017

I will try and assist.

Open the rear door and just remove the bushing on the side of the roller and refit the new roller.Hope this will help.

I am A certified Copier Technician.
It is so nice to give some help where possible and the forum is a great idea Thank You.Sometimes a picture speaks louder than words to find a solution.Should you find my help use full just give some credit for my effort please.
.Thank You.Copier-Pro
If you found this post helpful, you can let others know and also show your appreciation by clicking the “Accept as Solution”button, “Thumbs up" button!

#################################################################
I'M NOT AN HP EMPLOYEE AND DO ANSWER THESE QUESTION ON MY OWN BEHALF.
#################################################################

drewmun · ‎12-27-2017

I'm talking about the actual Secondary Transfer Roller (tube). I don't see a way of removing that part.

Please see attached images.

Alex-TATS · ‎12-27-2017

Hi @drewmun,

Please follow the guides bellow:

ALEX-TATS
Printer Engineer for a HP Platinum Partner
I am not a HP employee
If you found this post helpful, you can let others know by clicking the “Accept as Solution” button. You can also show your appreciation, with a kudos, by clicking the “Thumbs up" button!

drewmun · ‎12-27-2017

I can't see the guides you posted. Could you please repost links?

Thanks,

Drew

Alex-TATS · ‎12-27-2017

I can see them, they must be ok. Try logging in again and refesh the page. If that fails, maybe needs approval from an admin of the site because it contains images.

Either way, it is pretty simple process. All you have to do is:

Release the retainer clip (this is the white plastic at the left side of the roller, it's like a lever, you just pull it out a little bit and the rotate it ) and then rotate it clockwise until the pin on the clip aligns with the slot in the mounting bracket.

You do the same to the right side of the shaft.

ALEX-TATS
Printer Engineer for a HP Platinum Partner
I am not a HP employee
If you found this post helpful, you can let others know by clicking the “Accept as Solution” button. You can also show your appreciation, with a kudos, by clicking the “Thumbs up" button!

drewmun · ‎12-27-2017

Thank you, thank you. Did it with no issues.

Color Laser Jet Pro 200 Question (Secondary Transfer Roller)

Create an account on the HP Community to personalize your profile and ask a question