01-07-2020 02:36 AM
Hi everyone, we want to connect the printer to the network via WI-FI. The authentication is done via radius server. Unfortunately we have no possibility to make the appropriate settings in the EWS for radius.
What possibilities do we have to connect the printer to the network via radius. Many thanks in advance!
01-07-2020 08:28 AM
This is an older document but discusses HP Laserjet Networking http://h10032.www1.hp.com/ctg/Manual/c00731218
01-08-2020 12:22 AM
Hi, thanks for the answer. Unfortunately this PDF does not help me much. It refers to an HP Jetdirect Print Server. We do not need the Jetdirect Print Server because our printer ( HP Color LaserJet Pro MFP M479fdw ) must support Radius. Thanks for the effort anyway.
01-08-2020 01:08 AM
I checked my support documentation and did not find any relevant documentation for configuring this printer to a radius server and I will freely admit I am no expert on Radius. That said, this device does support 802.1x authentication, does support Enterprise WPA2 and has the option to install CA cert which I believe should be all the blocks you need to make this happen.
01-10-2020 02:54 AM
Actually, as much as I can see Radius is not a supported option for your printer (I do not have much knowledge on such in general, just considering the listed terms)
See the Security Management section of its specs (unless some other listed term may indicate the same?):
Say thanks by clicking the Kudos thumb up in the post.
If my post resolve your problem please mark it as an Accepted Solution 🙂