How do I add LaserJet 2200DN to network?

[RDCushing]

I just bought a used HP LaserJet 2200DN printer, but how do I assign an IP address to add it to our home network? Any help would be most appreciated. Thank you.

[davidzuts]

I trust the printer has come with an eio network card. If it has one you need to do a eio card reset with the instructions below. After performing the reset you need to print the config pages by pressing both buttons on the right side at the same time while the printer is ready. You should get 2 pages. The first with printer statistics and the second will have the network settings of the printer to include the ip address. Use that address to add to the printer. To make that address permanent type the ip address into your web browser and when the web page comes up go to network settings and change the method from dhcp or bootp to manual. The printer of course needs to be connected with a ethernet cable to your network and you need to wait about 2 minutes after the printer comes to ready before printing the pages to give the printer time to get an ip address from your router or network.

[RDCushing]

It comes with a built-in JetDirect connection. Is that the same as your reference to an EIO card? Also, you said "reset with the instructions below," but I didn't find any "instructions below." Did you omit part of your response?

[davidzuts · Accepted solution]

Sorry fogot to add the instructions.

EIO card reset
To perform a EIO card reset:

Turn the printer power off.
Press and hold GO.
Turn the printer power back on and continue to hold GO until the Attention light turns on.
Release GO.
The device lights will begin cycling from front to rear. The cold-reset process will run until
completion and the device will go to the ready state.

[RDCushing]

Thanks! You solved my problem!