-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
- HP Community
- Poly Video Conferencing
- Meeting Room Solutions
- Incoming Call Failed

Create an account on the HP Community to personalize your profile and ask a question

08-18-2011 08:47 AM
I am using m100 to connect from home to HDX-7000-Systems inside the company. My private network uses NAT and I opened the recommended Ports in my router, also the Windows firewall allows m100 to communicate with all destinations, the public WAN address is configured correctly.
When I call a HDX-7000 system, connection works fine. If anybody inside the company wants to call my System, the m100 is ringing. Configuring manual answer, the window with answer- and ignore-button appears, but clicking at the answer-button doesn't have any effect, the system continues ringing. Even automatic answer does not work. Any Idea?
08-26-2011 12:29 PM
Hi Charly61,
Are they trying to call you from the HDX 7000 system or are they trying to call you using local copies of the M100 software?
Typically, when you get the initial ringing, port TCP 1720 is configured correctly to allow traffic, but the UDP and TCP ports for media (Video / Audio / Content) have not be opened properly which is why the software continues to ring.
It gives the effect that the software is not answering even though you have selected the Answer button.
Please verify that the following ports are opened.
TCP
1720 & 1731
TCP & UDP
3230-3237

09-09-2011 05:04 PM
I have exactly the same set-up and exactly the same problem: using m100 to connect to an HDX 7000-series; can call in but can't answer inbound calls (it rings but nothing happens when i select 'Answer'). The HDX 7000 side is calling from that system, not another m100, when this occurs. I have verified that my firewall is open to TCP 1720, 1731 and TCP&UDP 3230-3237 and that all of these ports are being forwarded from my router to my PC. Any other suggestions?
Also, another problem is that when I try to call a different office that is using a desktop based polycom software solution (I forget the name but it's the predecessor to the m100 I think), I get an error message indicating that the 'far site can not be located'. When they try to call me, they've started gettting the same message even though they previously were able to call me successfully (although, as above, I was not able to answer). I should note that i get the error message above even when i try calling them by simply replying to the early inbound call from them that I was unable to answer but that registered in my call log.

10-31-2011 12:35 PM
I'm having similar problems.
m100 on my desktop calling a VSX8000, Lifesize Room 220, Tandberg C40.
All are set to autoanswer.
One is right down the hallway from me, they all ring, none of them autoanswer.
I ran down and selected to answer and it does not go off hook and answer,
just contnues to ring and then times out...