-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
- HP Community
- Poly Video Conferencing
- Meeting Room Solutions
- Polycom HDX 6000 entering Meeting ID

Create an account on the HP Community to personalize your profile and ask a question

07-08-2013 04:05 AM
Dear Community!
We just bought a HDX 6000 system, and tested with a Public service succesfully. Though when we tried to connect to one of our partners, and entered the IP, we got a screen requesting a meeting ID also. But we could not enter it any way.
I tried dialing the numbers by accessing the keypad (pressing #) I can hear the "bips" as I enter the numbers, but nothing appears on the screen. At the end I pressed # again, but nothing happens. After a while I get a message that no input has been detected. I tried without # with double # starting with a zero and a # at the beginning. Tried adding to the IP like this: x.x.x.x##meeting id or this: meeting id@x.x.x.x without success. All help would be really appretiated!
Thank you,
Tamas Galosi
Solved! Go to Solution.
Accepted Solutions

07-09-2013 03:22 AM
What a coincidence. I have just fixed an audio issue with HDX V3.1.x.x on Radvision MCUs running < V7.7.3. You could try getting the MCU up to V7.7.3 & the HDX to V3.1.1.3. The giveaway may be to try HDX V3.0.5 as my user has been holding @ HDX V3.0.5 awaiting Radvision MCU V7.7.3.

07-08-2013 04:54 AM
When you connect to the IVR requesting the meeting ID, double tap the Information Button on the IR remote control. It will show you call stats. Is the Audio Codec G.719? That doesn't support DTMF & might explain why your correct meeting room input is being ignored. VCPeteT.

07-08-2013 05:00 AM
Hi!
Thank you for your answer. I checked it but G.722.C. Is there any other possible reason?
I'm really without ideas now. Just for additional info, I try to send the numbers via the remote control, and also tried through
the web interface. I dont have touch control device.
Tom



07-09-2013 03:22 AM
What a coincidence. I have just fixed an audio issue with HDX V3.1.x.x on Radvision MCUs running < V7.7.3. You could try getting the MCU up to V7.7.3 & the HDX to V3.1.1.3. The giveaway may be to try HDX V3.0.5 as my user has been holding @ HDX V3.0.5 awaiting Radvision MCU V7.7.3.

07-10-2013 03:10 AM
Hi!
I upgraded to 3.1.1.3 but as RadVision side did not want to upgrade also, the issue remained. After that I went down to 3.0.5 and that finally solved the issue. Thank you very much for your help! You saved my day! 🙂
Thanx
Tamas