Create an account on the HP Community to personalize your profile and ask a question
Check out our WINDOWS 11 Support Center info about: OPTIMIZATION, KNOWN ISSUES, FAQs, VIDEOS AND MORE.
07-19-2020 12:16 AM
Product: hp envy 360 convertible
Operating System: Other
the built in microphone doesn`t work well, its impossible to have a call and not have any trouble with this issue, and I see I`m not the only one with this problem. I can`t believe the answer from the Hp "expert" is to try with an external one.
1 REPLY 1
07-21-2020 01:29 PM
@justinaqc Welcome to HP Community!
As I understand your internal microphone isn't working,
No worries, as I'll be glad to help you, that said, I'll need a few more details to dissect your concern & provide an accurate solution:
Have you been ensured it's enabled on recording devices under speaker?
Did you reinstall the drivers?
While you respond to that, here's a few things that should help:
There are a number of options in Windows sound settings that need to be configured so that the computer recognizes and works with the microphone. Use the steps below to modify the sound configuration as necessary for your microphone.
Open the Sound window
Connect the microphone to the computer.
In Windows, search for and open Sound.
The Sound window opens.
Click the Recording tab in the Sound window.
Figure : Recording tab in the Sound window
Then use the following steps to troubleshoot the microphone.
Step 1: Make sure the computer recognizes the microphone
In the Sound window, click the Recording tab.
Right-click an empty area of the Sound window.
Click Show Disabled Devices and Show Disconnected Devices.
Figure : Disabled and disconnected devices shown in the Sound window
If the microphone is listed as Currently unavailable or Not plugged in, disconnect it, then reconnect it to the port. If the microphone is still not detected, refer to the Check the microphone section of this document.
Test the microphone by speaking into it.
Look at the gray bars next to the device name on the Recording tab:
If the gray bars next to the device name change to green, the device is active and an audio signal is passing through the microphone port. The issue should now be resolved.
However, you might still want to make sure the microphone is set as the default microphone using the Step 2: Setting the default microphone section of this document.
If the bars remain gray and inactive, the computer is not recognizing a signal. Leave the recording tab open and refer to the Step 2: Setting the default microphone section of this document.
Figure : Sound window with Recording tab showing a detected signal for the Microphone device
Step 2: Setting the default microphone
The microphone you want to use might need to be set as the default microphone. Follow these steps to set your microphone as the default microphone:
From the Recording tab of the Sound window, select the port that you want to use. There could be one or more ports.
If the device you want to use contains a small circle with an arrow pointing down, the device is disabled. To enable the device, right-click the device name and select Enable.
(By the end of this article all the issues should be resolved)
Keep us posted,
If you would like to thank us for our efforts to help you,
Give us a virtual high-five by clicking the 'Thumbs Up' icon below, followed by clicking on the "Accept as solution" on this post,
Have a great day!
Be alert for scammers posting fake support phone numbers and/or email addresses on the community.
If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
Didn't find what you were looking for? Ask the community