cancel
Showing results for 
Search instead for 
Did you mean: 
Gritty
New member
1 0 0 0
Message 1 of 2
66
Flag Post
HP Recommended

Flashing black screen at boot

ExampHP ENVY x360 - m6-aq105dx
Microsoft Windows 10 (64-bit)

Help, had a hardrive failure, so I replaced with a new ssd.  Booted up to a new windows installation fine.  But after I downloaded and installed the drivers from HP's site, its now continually flashing a blank screen at boot. Seems like the chipset was the one that was installing at reboot. Cant get into the bios, tried to do a hard boot by removing the battery.  

1 REPLY 1
HP Support Agent
HP Support Agent
12,070 12,050 798 791
Message 2 of 2
40
Flag Post
HP Recommended

Flashing black screen at boot

@Gritty

 

Please remove the Hard drive, then try getting to BIOS to perform BIOS default

  1. Turn off the computer and wait five seconds.

  2. Press the Power button to start the computer and repeatedly press the F10 key to enter the BIOS setup menu.

  3. On the BIOS Setup screen, press F9 to select and load the BIOS Setup Default settings.

  4. Press F10 to Save and Exit.

  5. Use the arrow keys to select Yes, then press Enter when asked Exit Saving Changes?

  6. Follow the prompts to restart your computer.

Put back the Hard drive and let me know how it goes 😊

 

If the information I've provided was helpful, give us some reinforcement by clicking the "Solution Accepted" on this Post and it will also help other community members with similar issue.
 

 

 

 

KrazyToad
I Am An HP Employee

0 Kudos
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation