HP Notebook - 15-db0010au ( After Install SSD M.2 ) how to set up the bios ? #HelpMe

[88ronny]

I managed to install the SATA SSD m.2 hard drive with the brand WD Green 240 GB,

The first step I did after installing the hard drive was I entered the "Disk Partition or Disk Management" section. There appeared a new disk (SSD M.2) that was not formatted,

then because I want to clone windows from my hard disk to ssd m.2 my new sata,

I use Macrium Reflect, that process takes about 2.5 hours, until it finishes successfully clone.

my question here is,

1. How to set up this laptop Bios so that the 1st boot can be on my new SSD M.2 sata?

2. Why is my SSD M.2 SATA not detected when I want to choose booting using SSD M.2 even though in Windows 10 after we login is detected?

Please Help Me Thank you.

This is SATA M.2 SSD WD green 240Gb

This is SATA m.2 SSD on Disk Management: (Disk 1 = SSD M.2 SATA WD Green 240)

Disk Management

This is Macrium Reflect:

this is Macrium Reflect, i have clone Windows

This is Clone Completed:

successful clone

This is Bios on my Laptop:this is my laptop's BIOS displayThe UEFI boot device only displays 1 type of hard drive, only HDD not SSD is displayed

The UEFI boot device only displays 1 type of hard drive, only HDD not SSD is displayed.

HDD is the default hard drive for this laptop,

SSD is a M.2 SATA SSD that I successfully installed and detected in Disk Management.

Thank You Very Much. 

[banhien]

@88ronny 

Please try

(a) Remove old HDD and run on M.2 SSD only,

(b) After few days or a week (to be sure) format old HDD clean boot sector or signature and put it back

Regards.

[88ronny]

This is happen from 

HP PC Hardware Diagnostics UEFI, after i choose Diagnostic.

 

 

 

 

 

same SSD S.2 Sata not found...

 

[88ronny]

 

hmm sorry sir your opinion is not a solution.. SSD M.2 Sata still can not readed i have enter Bios and same.