cancel
Showing results for 
Search instead for 
Did you mean: 
  • ×
    Information
    Need Windows 11 help?
    Check documents and videos on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents and videos on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
Burtopia
New member
2 0 0 0
Message 1 of 2
154
Flag Post

Memory check failed QAG700-9B7A2J-MFGJ2K-40DX03 - installed new Memory

HP Recommended
HP Notebook - 14-Df0023cl
Microsoft Windows 10 (64-bit)

I originally posted here a year ago (original post and response is at the bottom of this post).  I followed the steps per the response, but the computer still will not boot up.  I don't remember how I even got the memory failure check code below to see if I am receiving the same error code.  From Amazon, I bought  [ Crucial RAM 16GB Kit (2x8GB) DDR4 2400 MHz CL17 laptop memory CTsK8G4SFS824A ].  When I went to install it, there were two slots available.  Only one spot was being taken up from the factory installed RAM.  The tabs on the RAM purchased from Amazon were not lined up to replace the original RAM without inverting the RAM card.  I did not have to invert the RAM card on the open RAM slot. 

 

 FIRST QUESTION: How do I repeat the test to get the failure code? 

SECOND QUESTION: Did I buy the wrong RAM?  

 

ORIGINAL POST:

____________________________

Memory check failed QAG700-9B7A2J-MFGJ2K-40DX03

 
HP Notebook - 14-Df0023cl
Microsoft Windows 10 (64-Bit)

What you were doing & experienced: my son's laptop was randomly shutting down.  I realized we had never installed anti virus software and decided to do a factory reset.  It's never booted up since.  I ran a test and thre memory failed.  Failure ID: QAG700-9B7A2JMFGJ2K-40DX03. HP support says it needs to be fixed but don't know what to do. wireless connection fyi

 

Hi:

 

The error code reported, Memory Module 1 Failure, means that you need to replace the memory module in slot 1 of your notebook.

 

If you never added memory, the specs for your notebook indicate that it has a single 4 GB memory module in one slot.

 

https://support.hp.com/us-en/document/c06166782

 

Below is the link to the service manual for your notebook where you can find the memory removal and replacement procedure.

 

http://h10032.www1.hp.com/ctg/Manual/c06146792

 

Since you have to take the notebook apart to replace the memory, you may want to consider adding more to it.

 

2 x 8 GB would give a decent boost in performance.

 

https://www.crucial.com/compatible-upgrade-for/hp---compaq/hp-14-df0023cl

 

This would be the kit I recommend from those listed...CT2K8G4SFS824A

 

https://www.crucial.com/memory/ddr4/ct2k8g4sfs824a/ct13520915

 

You won't be able to use the notebook until you replace the defective memory module.

 

Check Amazon for that kit part number, it may cost less than buying directly from Crucial.

1 REPLY 1
Photoray002
Level 15
12,679 7,626 1,309 4,332
Message 2 of 2
Flag Post
HP Recommended

@Burtopia   Try this if you haven't yet...

 

Remove one ram stick from the slot that originally had no stick and see if it will boot (don't fully put the case back together of course).

Then, swap the first stick with the second stick into the same slot. Test.

Then do the same thing for the other ram slot with each stick.

 

You might have either a bad stick or a bad slot. This is the best way to find out.

 

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation