cancel
Showing results for 
Search instead for 
Did you mean: 
Uchihart
New member
1 0 0 0
Message 1 of 2
69
Flag Post
HP Recommended

Preparing automatic boot loop

Hp envy 17t
Microsoft Windows 10 (32-bit)

Hi,

I have a HP envy 17t. It couldn't start from yesterday. Thinking it might be the screen is bad I connected it to my monitor and it is stuck in endleep preparing automatic repair cycle. Any suggestions how I might be able to fix this?

Any suggestions is greatly appreciated. 

Thanks. 

1 REPLY 1
Level 11
5,352 5,329 224 476
Message 2 of 2
41
Flag Post
HP Recommended

Preparing automatic boot loop

 

Hi
First:- Turn off the computer, press and hold the PWR button for 4 seconds.

Then - Leave only keyboard and mouse connected, disconnect all externally connected
devices such as Docking Station, USB storage devices, displays, and printers.
Unplug the AC adapter from the computer.

Next - Press and Hold the Power button for 15 seconds to Hard Reset.
Rinse and Repeat

AND/OR - Power on your PC, press Esc (repeatedly), then F2 at the prompt.
Choose System Tests (Fast Test does a 4 minute hardware check).
AND/OR
HOW DO I USE DIAGNOSTICS?

HP PC Hardware Diagnostics Windows is a Windows-based utility that allows you to run diagnostic tests to determine if the computer hardware is functioning properly. The tool runs within the Windows operating system in order to diagnose hardware failures. HP PC Hardware Diagnostics Windows comes pre-installed on new HP computers, but if not on yours, download here:- http://ftp.hp.com/pub/softpaq/sp93001-93500/sp93457.exe

Little Boy Blue, come blow your horn.


Lil_Boy_Blue
0 Kudos
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation