04-01-2019 09:28 AM
Have a EliteOne 800 G1 AiO, I have the AMD 7650 MXM graphics card along with the heat sink. I’ve installed but it doesn’t work properly. I get the RGB lines on the screen. Is there a setting or switch I need to set? If so where is it? Thank you for the help in advance
04-01-2019 12:58 PM
Did you buy card from HP or elsewhere ? Ther series only has one option to use.
AMD Radeon HD 7650A 2GB DDR3 MXM Graphics
You also need to install driver for video card which is
(No other newer driver from HP).
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.
05-16-2019 09:57 AM
Hi, I have the a similar problem. Installed Radeon 7650A MXM 2GB card into EliteOne 800 G1 Touch, set BIOS to UEFI mode to pickup card and rebooted. The machine is cycling through colours, one at a time. I cannot access Safe Mode at this point and have to reboot. The only way i can get back into settings is to remove the card and use default intel onboard.
Were you able to get your PC/card working and if so how?
05-21-2019 02:45 AM - edited 05-21-2019 02:51 AM
There is a little black connector (Circled in Red) just left to the MXM card, you have to unplug this and plug it into the slot just above (Circled in Blue)
05-22-2019 10:26 AM
Thanks, really appreciated!
I now have a working EliteOne 800 Touch G1 AIO with installed standard AMD Radeon 7650A 2GB MXM!
Makes perfect sense to have screen fed from a different output and I assumed, (incorrectly), that the onboard circuits would re-route the video signal automatically once a dedicated card was installed.
It's the first time changing the cable over has been mentioned as far as I can see from all related posts.
I updated the BIOS to 2.75 - through Windows 10/HP Tool - no issues at all.
I removed CMOS battery.
Installed MXM card with cable switched over to other/higher connector.
Re-inserted CMOS battery
Booted up machone
The machine restarted 3 or 4 times with a completely blank screen before Posting the BIOS text.
The MXM was recognised with Legacy mode enabled but I disabled it just in case.
I do not have heat pipes connected to my MXM, but have re-drilled a heatsink and used thernal paste on the GPU and removed the bracket from under the card to help with cooling. The heatsink is attached using 3 push pins through the existing holes in the card. I had to widen some of the fins on the heatsink to allow the pins to be inserted. I also put some electrical PVC insulation tape on the underside of the heatsink to insulate it from other components on the card.
I have been running the card consistently now over several hours and there are no heat/cooling issues.
System is running perfectly.with the back cover in position.