Guidelines
Are you having HotKey issues? Click here for tips and tricks.
Check out our WINDOWS 11 Support Center info about: OPTIMIZATION, KNOWN ISSUES, FAQs, VIDEOS AND MORE.
HP Recommended
HP Zbook Firefly 15 G7 Mobile Workstation (8WS03AV)

On my old HP Pavilion laptop running Windows 10, it goes to sleep when I command it and there are no log entries between the time it sleeps and the time it wakes up. The casing is bone cold.

 

Yet, on my HP ZBook, I'm finding that when putting it to sleep while plugged in, it doesn't really sleep. The casing is slightly warm many hours after sleeping and upon waking up. Checking the Event Viewer, I see many log entries across the time sleeping started and ended. I really don't want my ZBook doing anything. I don't want it checking for updates, accessing the Internet--NOTHING.

 

I've discovered that Windows 11 features several flavors of sleep now. There's "quick" or "modern," and then there's "deep." I really don't need my ZBook to be super-fast at startup, especially if it's going to make a sacrifice of wear and tear on the battery, and possibly CPU, RAM, and SSD (continued activity).

 

So my question: Can I configure my ZBook for deep sleep? I've not been able to figure it out yet. Or... is "Hibernate" the only other option?

"Trying to remain positive and optimistic in an ever growing negative and cynical world. Peace."
1 ACCEPTED SOLUTION

Accepted Solutions
HP Recommended

OK... so, once again... I answered my own question.

 

Apparently HP decided for the system firmware configuration of the ZBook line, there is S0 (modern standby) enabled while S3 (deep sleep) is consequently disabled. It's either sleep or hibernate.

gkline_0-1695444060128.png

 

Over on ElevenForum there's a tutorial where a registry edit can disable S0 and enable S3 (deep sleep).

Sure enough... it did show that Standby (S3) was enabled

gkline_0-1695501325925.png

 

HOWEVER, this did not behave as expected. In fact, putting the notebook into sleep by closing the lid did NOT put it in sleep mode. In fact, it caused the ZBook to remain wide awake. There were no log entries for 8 hours, but the notebook being in a confined space ended heating up significantly. The fan noise was very audible. So this fix is a fail.

"Trying to remain positive and optimistic in an ever growing negative and cynical world. Peace."

View solution in original post

1 REPLY 1
HP Recommended

OK... so, once again... I answered my own question.

 

Apparently HP decided for the system firmware configuration of the ZBook line, there is S0 (modern standby) enabled while S3 (deep sleep) is consequently disabled. It's either sleep or hibernate.

gkline_0-1695444060128.png

 

Over on ElevenForum there's a tutorial where a registry edit can disable S0 and enable S3 (deep sleep).

Sure enough... it did show that Standby (S3) was enabled

gkline_0-1695501325925.png

 

HOWEVER, this did not behave as expected. In fact, putting the notebook into sleep by closing the lid did NOT put it in sleep mode. In fact, it caused the ZBook to remain wide awake. There were no log entries for 8 hours, but the notebook being in a confined space ended heating up significantly. The fan noise was very audible. So this fix is a fail.

"Trying to remain positive and optimistic in an ever growing negative and cynical world. Peace."
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.