rebooting the iLO - NOT resetting it to factory default - from the command line

[wildmanwatson]

From time to time, the webgui will lockup and i'm looking for a way to reboot (NOT RESET) the iLO so that i can get into the webgui. from what i'm reading, u can click the reset button from the webgui to reboot but, all of the command line docs (ether from a ssh into the iLO or from hponcfg ) will reset the iLO back to the factory defaults values, then reboot it. i just want to reboot it, NOT RESET to factory defaults. any direction on this issue would be greatly appreciated.

[GBL84]

Dear Customer,

In such cases, first ensure ILO firmware is latest

If issue persist, reset ILO from hponcfg ( OS based application),if ILO GUI is not accessible. This will NOT erase any configuration. its like restarting ILO processor engine

Refer to http://h20564.www2.hpe.com/hpsc/doc/public/display?docId=mmr_kc-0115524

For CLI mode, please refer to: http://h20564.www2.hpe.com/hpsc/doc/public/display?docId=c03334058 page 28. 29

http://h10032.www1.hp.com/ctg/Manual/c03334051  (page# 270)

Hope this helps, for any further queries reply to the post and feel free to join us again

 **Click the White Thumbs Up Button on the right to say Thanks**

Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.

Thank You,

GBL84

I am not an HP Employee

[Hello_Man]

Hello,

I need to now if can i have the possibility to reset ILO servers without restarting my servers from Enclosure

FYI: 

I have access to the encoulusre but i can't access to ILO servers.