Dear Friends, Hoping and praying ALL is well.
I've been trying to boot into Linux Xenialpup 7.5 using a perfectly good USB version that was working fine.
Today after about 2 weeks of not using Xenial when I tried to boot into it I get a message *BOOT ERROR*
Never seen this before using Xenila or Tahrpup 6.0.5.
It will boot into Tahrup but it takes a round about number of steps that it never required before. It's usually only taken setting up the boot sequence making the USB first in the order.,etc... Then Saving and exit I believe it's F10 at that point.
What is the EXACT method of SETTING the Boot Sequence for this computer HP Pavillion dv7-3085dx? So, that it will NOT change unless I decide to change it?
Any help or suggestions highly appreciated...
Thank You,
Raphael
It has been a while since anyone has replied. Simply ask a new question if you would like to start the discussion again.
