Create an account on the HP Community to personalize your profile and ask a question
08-19-2022 01:27 PM
I can't upgrade to Windows 11 because the requirments says this PC must support secure boot.
I tried some troubleshoots on windows web page (Windows 11 and Secure Boot (microsoft.com) but it doesn't work because i can't see the UEFI Firmware settings.
Do you have any suggestions?
thank you previously
08-19-2022 02:43 PM
If Windows is installed in UEFI mode, see if this works to enable secure boot...
Step 1. Go into the BIOS and Load HP Factory Default Keys and see if Secure Boot becomes available.
Step 2. If it does not than go into the operating system and disable “Fast Boot” (Steps below).
Step 3. go back into your BIOS and try Load HP Factory Default Keys.
Step 4. enable Secure Boot at this point.
If W10 is installed in Legacy mode, you will need to reinstall W10 in UEFI mode by booting your W10 installation flash drive from the EFI USB Diskette on Key/USB hard drive.
Didn't find what you were looking for? Ask the community