bios

[faiq4]

Hi, My bios was auto update and its remove original HP Bios with Insyde H20, after that my SSD NVme is not detected and windows cannot be load, it erases the serial number and product id from the bios. UEFI options is also lock and i am unable to rollback it

[Irfan_06]

Hi @faiq4,

Welcome to HP Support Community.

Thank you for posting your query, I will be glad to assist you.

I see that you are facing an issue with your Laptop that is not booting up after the BIOS update.

-Perform a power drain on your PC.

1) Unplug the power cord from the PC & wall.

2) Disconnect the power cable from the AC adapter if it is a detachable part and keep it aside.

3) Press and hold the power button down for 15 seconds and release the power button, wait for about 30 seconds.

4) Plug the power cord back into the AC adapter, then connect it to the wall and to the charging port on your PC.

5) Power on the PC and check if it boots into Windows now.

-Update the BIOS for your PC by clicking on this link again manually using a flash drive.

Make sure you keep only the charger plugged in while updating the BIOS for your PC.

Click on the + sign next to BIOS and then download the file.

Open the file and follow the on-screen instructions to complete the update.

-Install all the pending updates for the Windows operating system following the below steps.

Go to Start > Settings > Update & Security > Windows Update and select Check for updates. If the upgrade is available for your device and you want to proceed, download and install it.

Please mark this post as “Accepted Solution” if the issue is resolved and if you feel this reply was helpful click “Yes”.

I hope this helps.

Take care and have a great day ahead!

Irwin6

HP Support