i am writing to ask about he touchpad on my laptop. I would like to know why it is that i can two finger scroll. Im using the hp stream 14 32 gb model. all though it was ages ago i recall two finger scroll being on this laptop however now it is not working. i have installed synaptics drivers and tried changing settings that wee suggested to change on certain websites and videos. Since this laptop is so bad it might not have two finger scroll touchpad does anyone know if it does have a touchpad that supports this and if yes a fix? thanks.
Two-Finger Scrolling is located under MultiFinger Gestures. If you do not see Two-Finger Scrolling, click the Arrow icon to the left of the MultiFinger Gestures checkbox.
Two-Finger Scrolling. If the checkbox next to Two-Finger Scrolling does not contain a check mark, click the checkbox until a check mark displays to enable scrolling.
Click the Settings icon to adjust scrolling settings. You can make the following adjustments:
Scrolling speed - Adjusts the speed of scrolling.
Enable vertical scrolling - Allows scrolling by sliding your fingers up or down on the touchpad.
Enable horizontal scrolling - Allows scrolling by sliding your fingers left or right on the touchpad.
Enable reverse scrolling direction - Changes the direction of scrolling.
Enable EdgeMotion when scrolling - Continues scrolling when your fingers reach the edge of the touchpad.
Enable Coasting - Continues scrolling after you lift your fingers off the touchpad.
Click the Close button to return to the properties screen.
Click the Apply button to apply your changes, and then select OK to exit the properties screen.
Refer this HP document for more assistance:- Click here
I hope that helps.
To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.
Sandytechy20 I am an HP Employee
Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".