-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
- HP Community
- Notebooks
- Notebook Wireless and Networking
- error msg trying to print wireless printer from laptop

Create an account on the HP Community to personalize your profile and ask a question
06-13-2019 02:52 PM
Im trying to print o my all in one HP jet printer office 5252 wireless from my laptop thats an Hp and its blue and was cheap at hp.com a year ago. I keep getting an error msg that reads "printer Validation failed". I dont know why. I dont have any updates available for my printer I checked. What can I do? I really need to print this registration form.
06-15-2019 05:24 PM
Let's start with a printer reset
(1) Turn the printer on, if it is not already on.
(2) Wait until the printer is idle and silent before you continue.
(3) With the printer turned on, disconnect the power cord from the rear of the printer.
(4) Unplug the power cord from the wall outlet.
(5) Wait at least 60 seconds.
(6) Plug the power cord back into the wall outlet.
NOTE: HP recommends connecting the printer power cord directly to the wall outlet.
(7) Reconnect the power cord to the rear of the printer.
(8) Turn on the printer, if it does not automatically turn on.
The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.
Wait until the warm-up period finishes and your printer is idle and silent before you proceed
Then update the Firmware from this Link: https://support.hp.com/us-en/drivers/selfservice/hp-officejet-5200-all-in-one-printer-series/1409573...
Next run the HP Print And Scan Doctor from this Link: ftp://ftp.hp.com/pub/printers/hppsdr/patches/HPPSdr.exe
Run PSDR v5.0.2
Once the PSDR detects the Printer, it will show up the IP address and Software Status.
Select the correct Printer and click on Next.
PSDR will check if the Printer is on the Network and communication between the PC and the Printer. Once the connection check is done, click on Fix Printing
Once PSDR goes through all checks and automatic fixes, click on Print a test page.
Regardless if PSDR printed the test page or not, click on “NO PRINT”
PSDR will then notify you that there is an update available, click on continue, and PSDR will apply the patch and ask for a reboot.
Post restart the PSDR will run automatically to check for more issue. If no issue found close PSDR.
Keep me posted how it goes 😊
If the information I've provided was helpful, give us some reinforcement by clicking the "Solution Accepted" on this Post and it will also help other community members with similar issue.
KrazyToad
I Am An HP Employee