Guidelines
The HP Community is where owners of HP products, like you, volunteer to help each other find solutions.
Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.

‎07-25-2014 06:20 AM

HP Recommended

I have 2 HP 2920 swtiches which I have setup 1 switch and want to copy the config to the other switch.

 

I am issuing the comamand and revieve the following error.

 

Closet-D-Accounting(config)# copy running-config usb 2920Config.cfg
Copying to USB device.
Cannot open dst file
Request failed.

 

I am using an NTFS USB drive, 500mb. I have also tried Fat and Fat32 with no luck.

 

Can't seem to get around this dst error.

2 REPLIES 2

‎07-25-2014 07:51 AM

HP Recommended

Hi:

 

You may also want to post your question on the HP Business Support Forum -- Procurve Switches section...

 

http://h30499.www3.hp.com/t5/ProCurve-ProVision-Based/bd-p/switching-e-series-forum#.U9Jgw3lOW9I

‎04-19-2015 07:33 PM

HP Recommended

ok, have you tried to format the USB drive as FAT32 (MS-DOS) ?

Thank you for choosing and using HP product and services.
Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.