How to enable bluetooth HP MINI 210 - 1002TU

[ghazy]

because Windows XP on my HP MINI 210 - 1002TU crashed so i have to re-install Windows XP and download the driver from here :

http://h10025.www1.hp.com/ewfrf/wc/softwareList?os=228&lc=en&dlc=en&cc=us&product=4093226&lang=en

after installed windows XP and the driver finished, i have problem that my Bluetooth cant be enable and the status is alway Disable.

anyone know how to Enable the bluetooth ?

thanks

[Vishnuchittan]

Unable to Connect to a Bluetooth Device in Windows XP http://h10025.www1.hp.com/ewfrf/wc/document?lc=en&dlc=en&cc=us〈=en&product=4093226&docname=c00583172#c00583172_M3 Doc No: c00583172 Once you fix the issue with Bluetooth, you can use the following doc to set up Bluetooth connection with XP...: http://support.hp.com/us-en/document/c00045315〈=en&product=4093226#DeviceEnabled Doc No: c00045315

[ghazy]

thanks for the info...

i have installed driver form here :

http://h10025.www1.hp.com/ewfrf/wc/genericSoftwareDownloadIndex?lc=en&cc=us&softwareitem=ob-41620-1

but in the device manager HP BLUETOOTH MODULE not macth with the driver on that link

and On the tray bar and control panel had a bluetooth symbol/sign buat when i click it the message error is :

"Bluetooth Device is not found

Plese verify that your bluetooth device is properly connected and turned on"

where i can turn on or enabled the bluetooth if on Wireless Assintant the bluetooth status are Disabled ?

thanks

[Vishnuchittan]

Manually reinstall the Bluetooth hardware

Depending on the design, a wireless radio card may support only a WLAN connection or it may support both WLAN and Bluetooth. Use the following steps to visually examine and reinstall the wireless card.

NOTE:

This method will require you to turn off the notebook and use hand tools to partially disassemble the PC.

1. Turn off the PC, disconnect the AC power supply and remove the battery.
2. Turn the notebook over and place it upside down on a clean and firm work surface.
3. Use a Phillips screw driver to loosen the screw that secures the cover over the network card. Remove the cover.

NOTE:

If the wireless radio hardware was not included with your HP notebook PC, there will not be a wireless card inserted into the slot. This must be purchased separately.

1. Remove the antenna wires from the card. Be sure to note the color of the wire on each connection so they can be replaced correctly.
2. Using your finger tip or a small wooden tool, spread the locking clips. This will release the card and allow one edge to rise slightly.
3. Gently move the card to loosen it completely, then press it firmly back into position so the card is seated fully in the holder. The gold connections on the card should be pressed completely into the holder. The locking clips click as the card snaps into place.
4. Install the antenna wires: the black wire attaches onto Main and the white wire attaches onto Aux .
5. Replace the card cover and tighten the retaining screw.
6. Turn the notebook right-side up, re-install the battery, re-attach the power cord, and restart the PC.

[ghazy]

thanks for your advise

but its too risk cause my netbook still in guarante cause  i buyed 3 months a go..

is there another way to setup my bluetooth ?

thanks

note: im sorry if my english not too good 🙂

[Q8]

Dear Sir Madam i have format laptop when format is complete i have miss my bluetooth when i search but he not available plz  tell me how i can found my bluetooth device