HP Deskjet 3522 -successful setup but no Internet connection

[Grandmotherboo]

It was working well wirelessly when I first setup with Verizon router, but we have changed to a cable service. I unsuccessfully tried to download disk to PC, but it didn't work. I have since deleted the printer from the PC and just want to print wirelessly from my iPad which worked successfully when using the Verizon router. After reading and trying to fix this myself, I wond if I have IPAdress issues?

[FixPrint]

Hi Grandmotherboo,

I hate to hear you are having issues.  Please see the steps below that may quickly resolve the issue.  If the issue continues Click Here.  We can also run the print and scan doctor to eliminate any simple issues the tool can resolve,Click Here.

Quick steps:

1. Connect printer to network use WPS button method (see page 33 of manual if needed)

2. Update IP address through software(all programs-HP folder-update IP/connect new/setup and software)

Or

1. Install the unit will USB cable

2. Convert to wireless(all programs-HP folder-printer setup and software-convert a USB printer to wireless)

Hope this helps, let me know how it goes.

Regards,

[Grandmotherboo]

Sorry but what Manuel has 33 pages? Also, don't know how to connect using WPS. Nor do I know how to change IP Address. I am educable, but I do need specific step by step directions if you are able. Thank you.

[Grandmotherboo]

Remember.....I am using an iPad....no PC.

[FixPrint]

Hi Grandmotherboo,

Thanks for the response.  Click Here to access the manual.  I have pasted the steps below, but you can access the steps by going to page 33 to view the WPS steps (this option will only work if router has WPS button). Test functionality after the printer connects to the network; if issues are persisting continue with the next link.  If you have access to a PC it will be easier to update or convert from there(with steps from previous post), however if you only have access the the Ipad Click Here to complete configuration steps.

WPS method:

1.Press the WiFi Protected Setup (WPS) button on your router.

2.Press and hold the Wireless button on the printer until the wireless light starts blinking. Press and hold for 3 seconds to start WPS push button mode .

NOTE: The product begins a timer for approximately two minutes in which the corresponding button on the

networking device needs to be pressed.

If the issue persists after utilizing the WPS method, click on the above link to configure from the Ipad device.

Hope this helps!

[Grandmotherboo]

I have no WPS on router. Issue not resolved. The printer is no connected to Internet. Printer appears to be set up successfully. I am sooooo frustrated.

[FixPrint]

Hi Grandmotherboo,

I hate to hear the issues persist.  Do you have any access to a PC?  If the WPS option is not supported by the router we can do a USB to wireless conversion or attempt connection with the  Ipad from the link in the previous post. What happened when the Ipad configuration was attempted?  Let me know the below, I would be happy to continue with the connection issue.

1. Press the wireless button

2. What is indicated (connected, on, etc.)?

3. What happened when attempting configuration with this Link? 

Regards,