cancel
Showing results for 
Search instead for 
Did you mean: 
ArchivedThis topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
Melvinrocker
New member
1 0 0 0
Message 1 of 2
354
Flag Post

HP Error Code oxc4eb827f

HP Recommended
HP 4630
Mac OS X 10.6 Snow Leopard

I need help, have looked online as well as discussion boards and cant find a resolution.  I have checked the warrenty and it shows expired.  When turning on my printer I get error code OXC4EB827F.  I have tried to take out the ink and it won't allow me.  It seems my only solution would be to buy a new printer, which i dont have the money for.  Please help me out.

0 Kudos
1 REPLY 1
sandytechy20
HP Support Agent
HP Support Agent
25,736 25,616 1,413 1,485
Message 2 of 2
Flag Post
HP Recommended

@Melvinrocker

 

This is a great location to get assistance! I read your post and see that you are getting 0XC4EB827F error on HP Officejet 4630 printer. I would like to help you resolve this issue. 

 

Perform a hard reset on the printer.

  • Turn on the printer.
  • Wait until the printer is idle and silent before you continue.
  • Disconnect the USB cable from the rear of the printer. If your printer has a network or wireless connection, leave it connected.
  • Remove the ink cartridges from the printer.
  • With the printer turned on, disconnect the power cord from the rear of the printer and from the wall outlet or power strip.
  • Wait at least 60 seconds.
  • Plug the power cord back into the wall outlet.
  • Reconnect the power cord to the rear of the printer.
  • Turn on the printer, if it does not automatically turn on.
  • The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.
  • Wait until the warm-up period finishes and your printer is idle and silent before you proceed.
  • Reinsert the ink cartridges, and then close the ink cartridge access door.
  • If you receive a prompt to print a calibration page, do so.
  • If you disconnected the USB cable, reconnect it to the rear of the printer.
  • Try to print.

Le t me know how it goes.

Cheers.

Sandytechy20
I am an HP Employee

0 Kudos
ArchivedThis topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation