• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
The HP Community is where owners of HP products, like you, volunteer to help each other find solutions.
Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
HP Recommended
Officejet Pro 9020
Microsoft Windows 10 (64-bit)

Had a supply system error on the cyan cartridge cleaned all the contacts on the print head and carriage no change

installed new OEM cyan and same results

1 REPLY 1
HP Recommended

@PrinterRecycler

 

Welcome to the HP support community.

 

Perform a power reset

  1. Turn on the printer, if it is not already on.
  2. Wait until the printer is idle and silent before you continue.
  3. With the printer turned on, disconnect the power cord from the rear of the printer.
  4. Wait at least 30 seconds.
  5. Plug back the power cable straight to a wall outlet and printer without any surge protector.
  6. Turn on the printer.

Update the printer firmware

Here are the steps:- Click here

 

Reseat the printhead up to three times

To clear the error message, you might need to reseat the printhead up to three times.

  1. Open the door to access to the ink cartridges.

  2. Wait until the carriage stops moving before you continue.

  3. Unplug the power cord from the rear of the printer.

       WARNING: 

    You must disconnect the power cord before reaching inside the printer.

  4. Lift the carriage latch, slightly lift the printhead, lower the printhead back into the carriage, wiggle the printhead left and right, and then lower the carriage latch to lock the printhead into place.

    Animation showing how to reseat the printhead in the carriage

  5. Close the ink cartridge access door.

  6. Reconnect the power cord to the rear of the printer, and then check the control panel for the error message.

  7. Sometimes error messages persist after inserting the printhead. If the error message persists, repeat the steps to reseat the printhead up to three times.

Refer to this HP document for more assistance:- Click here

 

Let me know how it goes.

To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.

Cheers.

Sandytechy20
I am an HP Employee

Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.