-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
- HP Community
- Archived Topics
- Printers Archive
- HP Officejet 6500 Makes a squeaking noise when printing

Create an account on the HP Community to personalize your profile and ask a question

11-15-2013 09:36 AM - edited 11-15-2013 09:47 AM
Nobody has yet posted the fix for this so i thought I better as mine has started doing it too. Mine is the HP Officejet 6500A Plus but the principle will still work with others.
When you have decide that the squeek is coming from the Print Head not the rollers ( print several blank pages in word and as the print head does not move then if the squeek stops then its the head )
1: open the top of the machine as if you are changing cartridges
2: let the head position in the middle of the opening
3: GENTLY push the head all the way to the left side
4: get WD40 and spray onto tissue/kitchen paper and wipe the chrome round bar the head slides on
5: DO NOT SPRAY WD40 EVERYWHERE INSIDE THE PRINTER !
6: Now repeat but pinch the chrome bar in thumb and forefinger and rotate it 1/4 turn and apply WD40 on tissue
7: Repeat 2 more times You will find that the paper will blacken a little this is what is causing the squeek (ink mist)
8: slide the head all the way to the right now and repeat 4 thru 7 again.
9 final thing i did was to insert carefully a paper sheild under the chrome rod and put up against the print head
where the rod enters it then apply a VERY MINIMAL amount of WD40 to the rod/hole junction replace the sheild on the other side and do the same.
10: Slide the head left /right a few times then clean off any over spray (IF ANY ) from surrounding area do not wipe the chrome bar leave oily. dont get WD40 on the tiny grey encoder ribbon this decides where the head is positioned
11: close the lid down and let the printer reset the head.
Print a few pages and you will find the screech has gone it is the dried ink mist on the rail that maked the head judder at very hi rate sounding like a squeek. The main thing is rotating the chrome slide rail to ensure you clean and lube all the way round it .
Hope this helps everyone I have had a lot of mileage out of mine and know others who have put hundreds of thousands of pages through theirs without problems just keep it clean use good ink and quality paper.
Marconi2
10-17-2014 02:04 PM
From reading all the postings here concerning "squeaking noise" of the 6600 printer, I guess my only choice is to buy a new printer . . .and it sure will not be a H/P printer.
This is ridulous and very poor customer support.
10-17-2014 03:59 PM
Pretty much. I ended up trashing the printer after support was useless. I still have an old as dirt HP Deskjet that is running fine and another OfficeJet that seems to be ok as well, but it was easier to just trash the bad printer and replace it than "fix it."
- « Previous
- Next »
