LeaserJet M1212nf MFP reset all settings

[Picardje]

ok then here it is again

This will help then 🙂

To restore the product to the factory-default settings, follow these steps.

1.

Turn the product off.

2.

Press and hold the Cancel button Start Copy button at the same time, and then turn the

product on.

3.

When the message Permanent storage init. appears on the control-panel display, release the

buttons.

[thyoes]

can you tell me where is the cancel button star copy....or you can give me a picture video to change it...

thanks

[Picardje]

Hi,

Open this link

http://support.hp.com/us-en/document/c01998934#N1027

figure 6 is the control panel of the printer with numbers and explenations of the buttons below

[thyoes]

Which option should I choose to find a language change?
whether the system setup or sevice?

[thyoes]

for all, I say thank you very much, because I've been able to change

[simon935]

Dear Picardje

I have a problem when upgrading my firmware to my 1212nf MFP, while i always progressed in the middle for over 30 minutes. I spotted the LCD screen displayed Initializing... (Chinese) and then disppearred and this repeats all the time...

I guess it keep restarted all the time...

Then i tried your method to reset the printer and it doesn't restored back to normal state, could you help me what can i do with this? Thanks.

[MihaHa]

Hold Right arrow and Cancel button while powering on the printer ... this will reset NVRAM. 

[simon935]

Finally I submitted the  printer for fixing, finally they quoted me with the  price equals to buying a new one! 

That really surprised me and I am quite sure the firmware upgrade had bricked the hardware.next time I have to take extreme care of upgrading a hardware without warranty. 

[Tkzee]

Switch the product off. Press and hold setup and cancel button simultaneously Switch it on, voila! Hope you this will resolve the problem.

[myralorenzo]

after said message appeared, a few seconds later, it was still Chinese