cancel
Showing results for 
Search instead for 
Did you mean: 
ArchivedThis topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
Ronteg
New member
2 0 0 0
Message 1 of 2
257
Flag Post

Re: Error 86:01 Hp Designjet T1100 after firmware updating

HP Recommended

Hi Everyone,

 

I have a problem im my hp t1100 , that happened after i updated the firmware yesterday ( error 79:04 ) . Sometime the printing is not finish yet or just half processing than got error 86:01(  paperjam case ) . So i cleaned the plotter with a vacum cleaner for pc and it can prints till finish the file or print full successfully image . But there was error cutting when the printing almost finish, i saw the plotter cut the paper on the top image ( arround 10 cm  )..

I was changed the belt, than changed all cartrifge and printhead, also updated the firmware..and now got that problem ....

 

Any suggestion ? thanks

0 Kudos
1 REPLY 1
davidzuts
Level 13
7,130 7,121 558 1,025
Message 2 of 2
Flag Post
HP Recommended

Two issue to check. First did you lube the rail so the carriage moves smoothly. Second if you changed the belt there is a good chance the bushing that sits on top of the carriage assembly may have fallen off or broken in half. Happens all the time. If the bushing the carriage sits to low and you get the 86 error. The other item to check is to make sure you positioned the belt correctly as the motor side inside is different then the pulley side inside and if the position is not correct then you can get the error.

ArchivedThis topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation