-
1
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
-
1
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
- HP Community
- Archived Topics
- Printers Archive
- Why is my scanner only scanning a quarter of the page I plac...

Create an account on the HP Community to personalize your profile and ask a question

09-07-2012 11:23 AM
I have a new HP Deskjet 3051A with a scanner. I just tried to scan a normal piece of paper and tried several times only to have the same result each time. It scans, but when I open the image on my computer, only about a quarter of the scanned document is shown. How do I change this?
09-07-2012 11:55 AM
Hi,
The default scan workflow configured to scan 6 x 4 inch picture. Make sure to change the scan settings not to crop the scanned area as following:
If you use Mac OS X 10.7 (Lion), make sure to install the Critical Update below, otherwise skip to the next step:
http://ftp.hp.com/pub/softlib/software12/COL41827/mp-101648-1/HP_Scan_for_Mac_OS_X_10.7_Update.dmg
Now change the settings as following:
1. Open the HP Utility and select your device.
2. From Scan Settings open the "Scan to Computer".
3. Click the "Scan Tasks" tab.
4. Select the Scan Shortcut used to scan, then click Edit.
5. In the section of Scan from an HP Device click on the blue triangle to enlarge the menu.
6. From the enlarged menu now open the drop-down menu next to Crop To and set as None.
7. Click OK and try scanning.
Regards,
Shlomi
Click the Yes button to reply that the response was helpful or to say thanks.
If my post resolve your problem please mark it as an Accepted Solution 🙂
02-21-2016 06:55 PM
I followed all the directions to install the software update and the update consistently failed to load 4x. Not sure what's wrong. I have an old MacBook Pro, admittedly, but I updated my operating system when I got a new hard drive and I'm using OS X 10.6.8, which, according to the HP site is compatible. Any ideas? Thanks!
02-21-2016 07:19 PM
No, wrong again. The software update says it's compatible with 10.6 OS, and I finally was able to install it. But, when I follow the directions you give here, I get t the step final step and I get this window: "Scan to computer cannot be enable" then it says: "The HP software required for Scan to Computer could not be located on this computer. Please download and install the latest HP recommended software for your device from http://www.hp.com/support, and then try again."
