Note on archived topics.
11-04-2015 05:08 AM
Hello everyone; my hp laserjet 4250n is firing a fuser error "50.2 Fuser Error" everytime i switch it on making it difficult to be used.
What's funny is that i replaced this fuser less than two weeks back. Tried all ways of going around it but failed .
Need help from somebody out there
11-04-2015 07:56 PM
The simple question is were you getting the error before you replaced the fuser. If no, then you got a defective fuser and you need to return it for replacement. If you were getting the error before, then you may have an issue with your dc controller or low voltage power supply.
11-04-2015 07:58 PM
The remanufactured fusers have lots of parts that already have a couple hundred thousand pages on them so they are a lot more failure-prone the new from HP.
If my post resolves your issue please click the accepted as solution button under it.
To thank a Tech for a post click the thumbs up button under the post.
You can even click both buttons. . .