Create an account on the HP Community to personalize your profile and ask a question
10-23-2015 04:32 AM
I have setup a new Server 2012 R2 server and installed HP P6000 Command View for our EVA to replace an old 2003 (Which didn't have a firewall enabled) server but it won't work when the Windows Firewall is enabled. I basically get the message "Connecting to Discovery" and then it says "Failed to connect to Discovery. The Management Group (MG) certificate may not be installed. Please refer to help for more information (Which I did).". The certificate is installed and I can log in ok when the firewall is disabled. I have opened the following ports in and out as listed in the installation guide 2372, 2374, 5988, 5989, 2376, 2377, 2379, 860, 2386, 3202.
Any help would be appreciated.
08-15-2016 07:10 AM
Can someone at Hewlett-Packard not answer this? I have hit the exact same problem. I have added all the ports listed in the manual, and it is not enough. How can I tell which ports need to be opened if the list in the manual is not correct?
08-26-2016 04:10 AM
Thanks for this answer. My workaround was to allow TCP protocol on any port for any program, while locking down the scope to the ip addresses of the SAN management server and my own PC. I will try also limiting the program to XF.
I had an exchange of emails with HP Customer Relations that ended with the advice to open a support case. I have not done this because the problem is with the documentation, not the installation.
08-30-2016 07:06 PM
I tried creating fw rule per your note, still having same issue.
"Failed to connect to Discovery. The Management Group (MG) certificate may not be installed.
Thank you in advance for any additional hints to get this dang thing to work again.
09-01-2016 08:35 AM
03-12-2017 02:16 PM - edited 03-12-2017 02:18 PM
This is the wrong company for Servers, Storage, Networking and Software. Please use the Hewlett Packard Enterprise Community: