Indicator light flashing red

[Babs26]

Indicator light is flashing red even after reset of printer 

[Jay_G24]

Hi @Babs26,

I'd like to help!

Is there an error message?

Meanwhile, try the steps below-

You might not see an error message when printing instant photos with the HP Sprocket 2-in-1 or when printing photos from the print queue. Restart the Sprocket to clear any errors, and then load genuine Sprocket photo paper.

1. Turn off the Sprocket, and then remove the paper cover.

2. Remove any loose photo paper from the input tray, and then make sure the photo paper is in good condition. Remove any severely bent, wrinkled, or torn photo paper from the stack.

      CAUTION: 

   Do not try to remove any jammed paper from inside the paper path. This can damage the paper path rollers.

3. Turn on the Sprocket.

   If there is jammed photo paper, the Sprocket feeds it through the output slot.

4. Wait until the Sprocket is idle and silent, and then remove any photo paper fed through the output slot.

5. Reload the photo paper with the HP logos facing down. Make sure to load genuine Sprocket photo paper, or the Sprocket might not print.

6. Replace the paper cover, and then resend the print job.

 You may also refer to the document- Blinking Red Status Indicator Light

Hope this helps! Keep me posted. 

And, Welcome to the HP Support Community. 

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.

Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping