cancel
Showing results for 
Search instead for 
Did you mean: 
Jin823
New member
1 0 0 0
Message 1 of 2
256
Flag Post

flashing red

HP Recommended

i have a 2 in 1 sprocket i bought new paper and reloaded it now it blinks a red flashing light i have only had it a year and used it a hand full of times. i have reset it, it says the top cover is not fully on after i reset it. i am at a LOSS and getting very frustrated with it. HELP lol 

0 Kudos
1 REPLY 1
sandytechy20
HP Support Agent
HP Support Agent
26,739 26,612 1,465 1,535
Message 2 of 2
Flag Post
HP Recommended

@Jin823

 

Welcome to HP support community.

  1. Turn off the Sprocket, and then remove the paper cover.

  2. Remove any loose photo paper from the input tray, and then make sure the photo paper is in good condition. Remove any severely bent, wrinkled, or torn photo paper from the stack.

       CAUTION: 

    Do not try to remove any jammed paper from inside the paper path. This can damage the paper path rollers.

  3. Turn on the Sprocket.

    If there is jammed photo paper, the Sprocket feeds it through the output slot.

  4. Wait until the Sprocket is idle and silent, and then remove any photo paper fed through the output slot.

  5. Reload the photo paper with the HP logos facing down. Make sure to load genuine Sprocket photo paper, or the Sprocket might not print.

  6. Replace the paper cover, and then resend the print job.

You can refer this HP support community for more assistance:- Click here

 

I hope that helps.

To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.

Cheers.

Sandytechy20
I am an HP Employee

0 Kudos
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation