cancel
Showing results for 
Search instead for 
Did you mean: 
ArchivedThis topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
ShariJones
New member
1 0 0 0
Message 1 of 2
154
Flag Post

Computer won’t turn on

HP Recommended
Stream - 11-ah113wm
iOS

Hi my HP stream laptop won’t turn on. Its been on the charger but it won’t turn on. I need help. 

0 Kudos
1 REPLY 1
Lil_Boy_Blue
Level 12
7,692 7,654 332 702
Message 2 of 2
Flag Post
HP Recommended

Hi
PLEASE POST ANY RESULTS.
First:- Turn off the computer, press and hold the PWR button for 4 seconds.

Then - Leave only keyboard and mouse connected, disconnect all externally connected
devices such as Docking Station, USB storage devices, displays, and printers.
Unplug the AC adapter from the computer.

Next - Press and Hold the Power button for 15 seconds to Hard Reset.
Rinse and Repeat; Re-Connect the AC adapter.

NOW begin checking/testing/proving the Hardware is fit for purpose.
Power on your PC, press ESC (repeatedly), then F2 at the prompt.
Choose System Tests (Fast Test does a 4 minute hardware check).

~~~~~~~~

 

This will not work for everyone, but you may be lucky?


HP Notebooks and Mobile Workstations -
No Power, No Boot, No Display When Power Button Is Pressed



NOTE: Be sure the battery is installed in the computer and it has sufficient power before continuing. Due to the design of the Embedded Controller/Keyboard Controller, the power supply must be disconnected and the computer must be powered with battery power to reset the Embedded Controller/Keyboard Controller.

Unplug the AC power from the computer.
Press and hold the power button for more than 12 seconds.
Release the power button (after at least 12 seconds).
The computer will power on and should boot normally after releasing the power button.
Re-connect the AC power to the computer.

NOTE: In case the battery is not charging after performing the steps to reset the Embedded Controller, unplug and re-plug in the AC power again.

0 Kudos
ArchivedThis topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation