cancel
Showing results for 
Search instead for 
Did you mean: 
ArchivedThis topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
MiWass
New member
1 0 0 0
Message 1 of 2
213
Flag Post

HP Stream 7 - after factory recovery - built in keyboard doesnt work!

HP Recommended
Stream 7
Microsoft Windows 8.1 (32-bit)

Have done a successful recovery installation of Windows 8.1 (used OTG USB cable to be able to click necessary steps during installation of windows.

 

However now when done and about to logon, nothing happens when I tap the display. If I connect the OTG USB cable with external keyboard I am able to logon.

 

I know that the tablet responds to tapping on the display becuase it works when Im in BIOS = are able to select values by tapping.

 

But what do I need to do in order to get it working without an external keyboard?

1 REPLY 1
kyle_b
Level 10
1,591 1,528 133 316
Message 2 of 2
Flag Post
HP Recommended

You would have to install drivers from hp.com following a fresh install of Windows to a Stream tablet, start with the Intel Chipset, Graphics, Camera and Audio Driver Pack which installs drivers for around 10 devices, reboot and install anything else that might be needed.  You can look in the Device Manager utility to see which devices are missing drivers.

Was this reply helpful? Yes No
ArchivedThis topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation