Guidelines
The HP Community is where owners of HP products, like you, volunteer to help each other find solutions.
Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.

‎12-12-2019 10:19 AM

HP Recommended
Product: HP elite compaq 8300 SFF
Operating System: Microsoft Windows 10 (64-bit)

I recently wanted to install windows 10 from USB hard drive, but when windows loads, the windows information disappears and I get an error saying the current input timing is not supported by the monitor display. Please change your input timing to 1440x900@60Hz or any other monitor listed timing as per the monitor specification.  

The monitor am using is dell 1909Wb.

 

When I change it with another monitor, message remain the same but says i change input timing to 1200x780.

 

Kindly, what resolution is windows at installation, please note wondows is not installed so i cannot change resolution by going to settings

 

The same hp has windows 7 and it boots well

Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.