• ×
    Information
    Windows update impacting certain printer icons and names. Microsoft is working on a solution.
    Click here to learn more
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Windows update impacting certain printer icons and names. Microsoft is working on a solution.
    Click here to learn more
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
The HP Community is where owners of HP products, like you, volunteer to help each other find solutions.
Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
HP Recommended
hp elitepad 900
Microsoft Windows 8.1 (32-bit)

good day, yesterday after updating the drivers the system went into a constant reboot, decided to put a new system, instead of secure boot pressed secure erase and got a dead tablet, boot option is completely empty and does not see boot flash cards, hp recovery writes hard disk (3fo), system diagnostics bios application error (501) what should I do and how to recover ????why the part responsible for loading of BIOS appeared in the windows system????

6 REPLIES 6
HP Recommended

I have also problem with hp elitepad 900 

15422290973948642027755117827991.jpg

 

Endlesly bootscreen in houers 

System test do all pass 

15422289834575334799116486282011.jpg

 

System info incorrect15422286979823696087788187370173.jpg

 

If i create an fat32 bootable usb it will show up 

If i enter boot from usb it ignores booting ftom it and continiu with boot screen 

 

Any help on this ? 

HP Recommended

I'm a little different.20181114_072136[1].jpg20181114_100009.jpg20181114_100022.jpg20181114_095942.jpg20181114_095952.jpg20181115_152850.jpg

HP Recommended

I managed to start the installation, by removing and connecting the BIOS chip without disconnecting the battery, the system installed, but all the serial numbers disappeared and does not enter the BIOS, how can I find out my license key for win 8?! ??????? there are only photos with id and numbers from BIOS, but there is no key (((

HP Recommended

My screen if a litle dif from yours 15425386323312895553734667307119.jpg

 

15425399066525559576193786551624.jpg

 

15425399931267691973045692812405.jpg

 

15425400892394683264549525086227.jpg

 

Im not have the secure erace etc 

But mine boots brom both usb and pxe but hangs when it starts the installing proces

It seems have a windows 

My battery is dead it only alive via docingstsmation 

If it is the battery that coses my elitepad to hand or not i dont know - Are your battery working ?

Chenatics over the moderboard could sort that teory 

Cose the battery has 7 cables and i have to know what needs power etc 

Docingstation maby not gives the power to all coponents only the battery and for it to  boot into bios

 

 

If this is not the case is there a way to flash the bios via usb bootable ?

 

Lifting the bios 8s the same as removing the battery 

It lose its power and it goes defoult

In my case it says 01/01/12 in diagnostic bilt in

So maby the battery cose the problem in my case 

 

 

So scematic over the moderboard could sort that teory 

 

HP Recommended

decided to watch the correct position of the BIOS in the carriage,for the programmer , the latch lifted sick ,and then I remembered that the power is not turned off)))) ,actually gathered everything back ,launched ,writes not found the numbers all in BIOS not to come in ,plug in the stick ,picks up the download ,but a flash drive inserted with 8.0 ,shut down , connect with the silence 8.1 again ,same error ,I try cases to go to BIOS ,BIOS is loaded ,and the menu there was an option of booting from the stick ,actually rolled 8.1 now, about the the keygen I did not look,even though the file I'll post it on SSD (but on reboot did not swear on the numbers already) ,and generally I realized I have a BIOS chip chudit ,but as ordered and the programmer and the chip you probably will get and put fresh )

the system is now working ,but there is no BIOS at all and don't have serial numbers ,how can I restore the win 8 key ?)

HP Recommended

Bios Configuration Utility 3.2.3.1 ---cmd --- cd C:/Program Files/Hewlett-Packard/BIOS Configuration Utility/----BiosConfigUtility.exe /get:"config"-----in the program folder that is created .txt his edit your numbers save----BiosConfigUtility.exe /set:"config.txt"                 should pick up numbers

 but this is if the system is loaded....

if not, it may help to turn off the button, disassemble the tablet without disconnecting the battery remove the BIOS chip, press the power button, and connect the BIOS chip in place, then disconnect the battery and connect again, it helped me

HP install the bad BIOS chip, they often go down   

here on the forum, generally there is somebody from tech support , or any tablet such and support ???

if there is ,tell me how I activate windows key is missing along with the serial numbers from the BIOS all the numbers restored restored not only key windows

Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.