• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
The HP Community is where owners of HP products, like you, volunteer to help each other find solutions.
Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.

‎03-10-2021 01:57 AM - edited ‎03-10-2021 02:09 AM

HP Recommended
Product: HP ENVY 13-ba1000
Operating System: Microsoft Windows 10 (64-bit)

just yesterday i got notification from windows update to install HP Inc Firmware 15.11.0.0 (it is bios update F.11), and after installing it it shows "The System BIOS update is complete" below that "Upon Restarting the screen may be blank for a few minutes and various LED Lights may flash .Please do not attempt to interrupt or power down during this time". After that i click "Continue Startup" then the screen goes blank and the power button key repeatedly blinking for 1 minute and after that stop blinking. only battery indicator light that on until now.  it said the "Upon Restarting" but almost 4 hours have passed my laptop not restarting, it is supposed to restart and back to my windows start menu like the previous bios update F0.6. So, after 4 hours i decided to press the power button key and then it start repeatedly blinking again for 30 seconds and enter the windows start menu. I checked my bios version through msinfo32 and it shows that my bios version is F.11 .But I fear the newest HP ENVY 13-ba1000 bios version F.11 has a problem and my battery drain faster than previous bios version ( balanced mode in HP Command Center and power mode is Better Battery) and also the performance is declining compare to the previous bios version ( i set Performance mode in HP Command Center and the power mode is best performance while plugged in).

Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.