• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
The HP Community is where owners of HP products, like you, volunteer to help each other find solutions.
Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.

‎07-28-2021 10:21 AM

HP Recommended
Product: Laserjet Pro M454dn
Operating System: Microsoft Windows 10 (64-bit)

Will only boot to MFG MODE and stays that way. Regardless of trying a hard boot cycle, different outlet, holding power while turning on etc. I cant even get it to let me cycle the settings to do a manual reset on it. Its not a network printer only local. There is a slight hope in that if i hold the power while turning it off it will let me cycle the settings. Albeit its around 3-4 seconds and wont let me go fast enough to reset it. Any ideas?

Category:
Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.