• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
Guidelines
Are you having HotKey issues? Click here for tips and tricks.

‎03-19-2018 05:07 AM

HP Recommended
Product: Z440
Operating System: Microsoft Windows 10 (64-bit)

Hello,

I have bought a Z440 system with 2xHDD 500GB. The disks should work in RAID1 configuration. I have tryed to reboot with only one HDD and the station gives me a lot of errors also if one HDD is powered off the system crashes completely. 

According to the doc found on HP site for configuring my disks in RAID I should enter in POST phase with CTRL+C (or I or H) and from LSI 2308 menu confgure my RAID matrix. But the new layout of BIOS does not gives me the posibility to activate view of POST messages and as a result LSI menu is not accessibile. 

From Winwows 10 64bits I have tryed to use Intel RST to view somw status of the RAID matrix or the status of the disks but it also doesn't gis me access to configuration menu. 

I need an urgent sollution to make RAID working properly on my computer and to find an application or commands (CLI) which can give me data about the status of the disks and a replacement procedures in case of a disk failure.

I thank in advance to anyone who can HELP me!!!

 

Best Regards,

Zamfirel

Who Me Too'd this topic
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.