-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
- HP Community
- Desktops
- Business PCs, Workstations and Point of Sale Systems
- HP Z2 Tower G5 - how to make simple RAID 1 setup, non-boot

Create an account on the HP Community to personalize your profile and ask a question
05-12-2021 10:19 PM
Simple one, but I can’t figure it out in the BIOS screens - I just want to configure my 2 spinning SATA disks as RAID 1 using the built-in features. Data only, not boot. The documentation I can find is all for older systems. Any pointers please?
Solved! Go to Solution.
Accepted Solutions
05-13-2021 04:15 PM
Please use the following Guide
https://support.hp.com/au-en/document/c05914431
Regards.
***
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.
05-13-2021 04:15 PM
Please use the following Guide
https://support.hp.com/au-en/document/c05914431
Regards.
***
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.
05-16-2021 01:34 AM
Thank you, Banhien. This worked. The only difference was in my BIOS settings in Step 3, there was no POST prompt configuration setting. Ignored, and all went fine.
"Under System Options, select Configure Storage Controller for RAID and POST Prompt for RAID Configuration."