• ×
    Information
    Windows update impacting certain printer icons and names. Microsoft is working on a solution.
    Click here to learn more
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Windows update impacting certain printer icons and names. Microsoft is working on a solution.
    Click here to learn more
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
We have new content about Hotkey issue, Click here to check it out!
Locked

‎05-12-2021 10:19 PM

HP Recommended
Product: HP Z2 Tower G5 Workstation
Operating System: Microsoft Windows 10 (64-bit)

Simple one,  but I can’t figure it out in the BIOS screens - I just want to configure my 2 spinning SATA disks as RAID 1 using the built-in features. Data only, not boot. The documentation I can find is all for older systems. Any pointers please? 

1 person had the same question
1 ACCEPTED SOLUTION

Accepted Solutions

‎05-13-2021 04:15 PM

HP Recommended

@stansley 

 

Please use the following Guide

 

             https://support.hp.com/au-en/document/c05914431

 

Regards.

BH
***
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.




View solution in original post

Was this reply helpful? Yes No
2 REPLIES 2

‎05-13-2021 04:15 PM

HP Recommended

@stansley 

 

Please use the following Guide

 

             https://support.hp.com/au-en/document/c05914431

 

Regards.

BH
***
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.




Was this reply helpful? Yes No

‎05-16-2021 01:34 AM

HP Recommended

Thank you, Banhien. This worked. The only difference was in my BIOS settings in Step 3, there was no POST prompt configuration setting. Ignored, and all went fine.

 

"Under System Options, select Configure Storage Controller for RAID and POST Prompt for RAID Configuration."

Was this reply helpful? Yes No
Warning
Be alert for scammers posting fake support phone numbers and/or email addresses on the community.
If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.

Didn't find what you were looking for? Ask the community

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.