cancel
Showing results for 
Search instead for 
Did you mean: 
The HP Calculator Community Message Board is moving. While we prepare for the move, we are unable to accept new postings. During the move, you can look for help from other users by visiting https://www.hpmuseum.org/ . Or if you need technical support for your calculator visit: HP Calculators. .
MaCro3d
New member
1 0 0 0
Message 1 of 1
273
Flag Post

Z840 No GUI after BIOS update. Systems BIOS update to 2.56 also can not make any changes in menu

HP Recommended
Z840
Microsoft Windows 10 (64-bit)

The MVMe on my zturbo drive was def. so I replaced it with a new MVMe card. Next I updated the BIOS to v2.56, after that I did a clean

install of Windows 10 including all HP drivers from the HP Support center. When I try to install the Nvida driver for my

Quadro M4000, I noticed that the windows device manager does not see the card. During the driver install the screen went blank, and

the system crashed. After I restarted the system and entered the BIOS, the GUI was no longer there, only a legacy interface.

I can no longer make any changes in the BIOS, when I try it locks up. Also every time I try to install the Nvidia driver the system crashes

and corrupts my Windows installation.

Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation