Guidelines
We have new content about printers, Click here to check it out!
Get help with Large Format Printers, with direct access to all Large Format Knowledge Center· Ask anything · Find anything · Share anything at HP LKC
HP Recommended
HP DesignJet Z9+ 44-in PostScript Printer

Boot fails with "system error 0001-0003-0001. Have extracted the diagnostic package to a USB drive but am unable to read it. Its a "TRB" file extension. It's networked via LAN connection and I verified that the LAN connection is good but I can not access the embedded web server via https://printer IP address/hp/device/support/serviceSupport. Also I noticed on the back of the unit about 4 inches above the LAN connection are 3 orange LED's on solid.

1 ACCEPTED SOLUTION

Accepted Solutions
HP Recommended

Hi @Skyvokk 

 

The diagnostics package can be read only by HP higher support level engineers.

The error 0001-0003-0001 is related to the internal formatter which along with the JDI PCA have to be replace.

I suggest you if the printer is under warranty contacting HP but if not then contacting a service provider in your area.

I am an HP employee

View solution in original post

1 REPLY 1
HP Recommended

Hi @Skyvokk 

 

The diagnostics package can be read only by HP higher support level engineers.

The error 0001-0003-0001 is related to the internal formatter which along with the JDI PCA have to be replace.

I suggest you if the printer is under warranty contacting HP but if not then contacting a service provider in your area.

I am an HP employee
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.