Designjet Z3200 Error 44:10

[Lucien54]

My Designjet printer Z3200 give me the code error 44:10 and I cannot print anything.

3 months ago I have change the Service Station and everything work well.

Is there someone that can help me with this problem?

Thank you.

[skuks · Accepted solution]

Code

44:10

Description

Fan Electrical fault, or not connected.

Remedy

• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Check that the Aerosol Fan cable is not damaged and is correctly connected to the PrintMech PCA • Replace the Aerosol Fan Assembly. • If the System Error continues, replace the PrintMech PCA.

[JackB44]

When you changed Service Station did you changed FAN on it or you replaced old FAN on new service station.

P.S. This fan is for aerosol management in Printhead cleaning. Knows to stuck caused by ink.

(this is one of possibilities)

[Lucien54]

When I change the Service Station, the fan was full of ink.  I clean it the best that I could and it worked well for 3 months.  Westerday I order the aerosol fan and a PrintMech PCA.  

[Lucien54]

I change the aerosol fan and everything is working well.  That was the problem.  

Thank you everyone for the help.