cancel
Showing results for 
Search instead for 
Did you mean: 
Get help with Large Format Printers, with direct access to all Latex Knowledge Center · Ask anything · Find anything · Share anything at HP LKC
Lucien54
Level 1
3 2 0 2
Message 1 of 5
1,568
Flag Post

Solved!

Designjet Z3200 Error 44:10

HP Recommended
Z 3200
macOS 10.13 High Sierra

My Designjet printer Z3200 give me the code error 44:10 and I cannot print anything.

3 months ago I have change the Service Station and everything work well.

Is there someone that can help me with this problem?

Thank you.

1 ACCEPTED SOLUTION

Accepted Solutions
skuks
Level 5
249 247 13 34
Message 2 of 5
Flag Post
HP Recommended
Code

44:10

Description

Fan Electrical fault, or not connected.

Remedy

• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Check that the Aerosol Fan cable is not damaged and is correctly connected to the PrintMech PCA • Replace the Aerosol Fan Assembly. • If the System Error continues, replace the PrintMech PCA.

View solution in original post

Was this reply helpful? Yes No
4 REPLIES 4
skuks
Level 5
249 247 13 34
Message 2 of 5
Flag Post
HP Recommended
Code

44:10

Description

Fan Electrical fault, or not connected.

Remedy

• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Check that the Aerosol Fan cable is not damaged and is correctly connected to the PrintMech PCA • Replace the Aerosol Fan Assembly. • If the System Error continues, replace the PrintMech PCA.

View solution in original post

Was this reply helpful? Yes No
JackB44
Level 3
60 60 1 14
Message 3 of 5
Flag Post
HP Recommended

When you changed Service Station did you changed FAN on it or you replaced old FAN on new service station.

P.S. This fan is for aerosol management in Printhead cleaning. Knows to stuck caused by ink.

(this is one of possibilities)

Was this reply helpful? Yes No
Lucien54
Author
Level 1
3 2 0 2
Message 4 of 5
Flag Post
HP Recommended

When I change the Service Station, the fan was full of ink.  I clean it the best that I could and it worked well for 3 months.  Westerday I order the aerosol fan and a PrintMech PCA.  

 

Was this reply helpful? Yes No
Lucien54
Author
Level 1
3 2 0 2
Message 5 of 5
Flag Post
HP Recommended

I change the aerosol fan and everything is working well.  That was the problem.  

Thank you everyone for the help.

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation